UCM6510 not accessible at default IP- please help


Hi- I just received a UCM6510 and I did a factory reset. It is showing at the default ip of but I cannot access that on my network- any suggestions?


Are you in SWITCHED or ROUTED mode on the 6510?


Factory reset, plugged in to the lan port


Check certificate, by default browser will show you alert.


Thank you. I just set it up at home as I needed to change my internal DHCP IP address range anyway because I am setting up a VPN between my locations.


your local IP needs to match that subnet to connect.
alternatively switch it to route mode and let it give your pc an ip address.


It is probably in Routed mode. Connect your PC to LAN port and try to access it with LAN IP