hello i have problem with GN7610
in Discovery Tools device still slave even if I reset it
GWN7610 problem
said31
#1
damiano70
#2
I think it’s normal, I don’t use that tool, but since the GWN is in the “factory” state, it is assumed that it is installed by itself, therefore slave,
master / slave is a condition that can only exist with at least 2 A.P.
However the status of master or slave is only displayed by the Master cell after the master / slave system has been created
In any case, I suggest you update the FW and do a format facotry via SSH.