GS Wave bug


#1

I think I found an annoying bug on UCM when using GS Wave.
Enabling Pbx Settings / Sip Settings / ToS -> Trust Remote Party ID
is
Enabling Pbx Settings / Sip Settings / ToS -> Trust Remote Party ID
GS Wave is registered but only makes internal calls, it is impossible to make external calls.
Disabling these two items GS Wave works both internally and externally, but it creates another problem, no longer works “Refer-To Use Target Contact”
which is a very useful function.
It seems obvious to me that it’s a bug (unless there are other settings to do).
I lost 4 hours to record GSWave for this anomaly. It usually takes 2 minutes at most :face_with_symbols_over_mouth::face_with_symbols_over_mouth::face_with_symbols_over_mouth:

n.b.: Problem with UCM6202 1.0.19.20 (but also with 1.0.18.13). GSWave for Android updated.


#2

@damiano70, in my experience bug reports are best handled by submitting them to the Help Desk rather than via this primarily user-to-user support forum.


#3

hi @drostoker I know the procedure and I have already opened a Ticket, I wrote it here to see if anyone wanted to do this test for comparison if he too presents the problem.


#4

Then perhaps you should have said so instead of assuming we’d know this…


#5

if every post that everyone does writes everything becomes a book, I reported a post, it was obvious that if some good soul wanted to do a test …