Early Dial


#1

Hello,

Any one can please help me to set up “early dial” in UCM 6510 , whether it’s supported with this UCM model ? trying to avoid dialing delay of an out bound call without # or press dial at the end of dial sequence .


#2

This is end point problem unless you try use FXS port. FXS port need # as analogue do not have signal that show you end up putting number to dial.


#3

Marcin is correct. The UCM only compares the dial string as seen from an extension and then based upon same determines the route the outbound call should take,

You need to examine the dial string functionality within the phone as that is the place where what and when sent is determined.