Search
FXS problem with .21 firmware
anesfhs
We have a GXE5204 with two PSTN lines on FXO ports and a real fax machine attached to the first FXS port. This used to work. After upgrading to 1.0.1.21 beta, the fax machine is unable to make calls. Only the first two or three of the dialed digits are forward to the PSTN line. The 5204's own call log confirms this. Plugging another phone in place of the fax machine makes no difference.Reverting to version 1.0.1.16 firmware solves the problem. I haven't had a chance to test this on 1.0.1.20 yet.
- Dave
Not sure if this is the same problem (V1.21) but I have added our former fax PSTN line today as trunk 1 and can make & receive calls on it ok. However, incoming calls make phone/fax port#1 ring even though this is not included in the hunt group assigned to trunk#1. Also phone/fax port#1 seems to be nailed up to trunk 1 for outgoing calls too, ie: it cannot dial any internal extensions and is providing dial tone from trunk#1 rather than the pbx.I had hoped that the trunk1&2 would fall-over to connect to phone/fax ports 1&2 in the event of a power failure but wasnt expecting it to be the default setting. Unless I have misunderstood something ?
